![]() But I did have to run out for a short while while the first lot of grains was draining so that added some unnecessary and unwanted time to the process. I think the first mash went in about 8:30, and I didn't start boiling until after 2pm. If you have a question for the experts or want to share your expertise, email us at or visit our website at my first reiterated mash on the weekend as noted in the brew day thread. This means we would need another 10 pounds (4.5 kg) of grain to reach our 1.080 target! In practice, it may not be quite that bad, but even using a 60 percent efficiency number means an extra 6 pounds (2.7 kg) or 36 pounds total (16.3 kg) is needed for our 1.080 beer. For an extreme case like this where we’ve doubled the grain used, it could be as much as 25–33 percent lower, which means our 72 percent brewhouse efficiency could drop as low as 50–60 percent. The bottom line is that when you brew a big beer, you will get lower efficiency. When we make a normal beer, we have enough water running through the grain bed to get good extraction, but when we double the grain used, we’re taking the high-gravity runnings (the first two thirds of gravity) but discarding the tail end (the last one third), so mashing a big beer is much less efficient. big beer, we can see that doubling the amount of grain to produce the same amount of wort is much the same as the parti-gyle method above. The problem is that we’re still producing only 13 gallons (49 l) of wort from the mash, so we’ve doubled the amount of grain but are making the same amount of wort.Ĭomparing the two cases of normal vs. If we up that to a 1.080 beer, we now need 30 pounds (13.6 kg), or double the amount of grain, to reach the higher gravity assuming the same efficiency. At 72 percent brewhouse efficiency, it would take about 15 pounds (6.8 kg) of grain to reach 1.040 original gravity assuming just over 13 gallons (49 l) of wort is produced pre-boil. Lets consider a 1.040 beer brewed on a 10-gallon (38 l) system. (For more information about parti-gyle, see Practical Parti-Gyle Brewing) There is a method called “parti-gyle” brewing that does exactly this-makes one high-gravity beer from the first runnings and another low-gravity beer from the second half. ![]() ![]() In fact, it is not uncommon to get two-thirds of the gravity points extracted in the first half of the runnings and only one-third of the gravity points in the second half of the runnings. If we look at a normal lautering process, we see that the gravity coming out of the mash tun during the early runnings is quite high, and then it tapers off as we run more wort through the grain bed. Lower efficiency means lower gravities and even more grain to reach your target. Not only does this push the limited capacity of your mash tun, but it also lowers the efficiency of your brewing system. These beers typically involve original gravities of 1.080 or higher, which means you may be using double the amount of grain (or more) that you typically brew with. A Craft Beer & Brewing Magazine reader recently asked us the following question: I recently tried to brew a high-gravity imperial stout using all grain, but my original gravity came in much lower than predicted, and I don’t know why.īrewing a high-gravity all-grain beer can be a challenge, and getting it right requires some forethought and planning. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |